Arroyo Instruments TECSource 5305 User Manual

Lists the items included with the TECSource, such as manual, CD, and power cord.

Describes optional accessories like cables and rack mount kits for the TECSource.

Explains symbols used in the manual, like Caution, Warning, and Earth Ground.

Provides crucial warnings regarding qualified personnel, electrical shock, and user-serviceable parts.

Guides through initial steps like voltage selection, power-on, and basic parameter adjustment.

Details the process of selecting the correct input voltage for the unit to prevent damage.

Explains how to turn on the TECSource after correct voltage selection and connection.

Covers proper airflow management and installation within standard 19-inch racks.

Advises on operating temperature, humidity, and warm-up time for optimal accuracy.

Describes the buttons, adjustment knob, and VFD display on the front panel.

Explains the function of the Error, Output On, and Remote LEDs.

Details the three control modes: Temperature, Resistance, and Current.

Describes the information shown on the main display, including set point and measurements.

Explains displayed measurements and the use of temperature, sensor, and current limits.

Introduces the menu structure and key parameters like Mode, Mount, and I Lim.

Covers PID parameters (P, I, D) and sensor configuration options.

Details settings for temperature ramp rate, tolerance, and external fan operation.

Explains sensor calibration coefficients and RS232 communication settings.

Covers display mode, brightness, audible feedback, and knob settings.

Details the pin configuration of the 15-pin DB connector for TEC output.

Explains the function of the ID pin and remote sensor pins for advanced operation.

Describes the USB Type B and RS232 DB-9 connectors.

Lists available cables for connecting the TECSource to fixtures, including current ratings.

Guides on setting the mount type in the menu for automatic parameter adjustment.

Explains how the unit behaves when controlled via computer over USB or RS232.

Step-by-step guide to install USB drivers and identify the COM port.

Discusses thermistor operation, sensitivity, and typical resistance curves.

Explains the Steinhart-Hart equation for thermistor temperature calculation.

Details the IEC751 equations used for RTD temperature measurement.

Explains the difference and setup for 2-wire and 4-wire RTD measurement modes.

Describes using Sens Cal M and Sens Cal B for sensor measurement compensation.

Explains how to set a specific rate for temperature changes using T Rate.

Details how to change the increment for manual set point adjustments.

Explains settings for fan speed (Off, Slow, Fast, Custom) and operating modes (Auto, On, Delay, Cool, Heat).

Covers gain settings and manual tuning of the PID loop parameters (P, I, D).

Guides on how to initiate and perform the automatic PID parameter tuning.

Explains how to perform AutoTune remotely using commands.

Discusses how the unit manages thermal load and prevents overheating.

Illustrates the safe operating voltage and current limits for the 5305 model.

Shows safe operating voltage and current limits for other TECSource models.

Lists specifications for current, voltage, power, and temperature control.

Details specifications for measurement channels, sensors, connectors, and physical attributes.

Lists error codes, their descriptions, and potential causes.

Lists remaining error codes, their descriptions, and potential causes.

Information on cleaning, fuse replacement, and troubleshooting blown fuses.

Details how to obtain service, repair, and contact Arroyo Instruments.

Outlines the product warranty period, coverage, and exclusions.

Declares compliance with EU directives like EMC, Low Voltage, and RoHS.