ARTE PHOENIX - Heating During Seasonal Change or in Adverse Weather Conditions; Ventilation Kit (Optional)

INSTALLATION & USER MANUAL ENERGY EFFICIENT WOODSTOVE | PHOENIX
10 | Page
ARTE® PHOENIX woodstoves allow fresh air from two different inlets:
Inlet
BEHIND
Inlet
BELOW
6.3.4. Heating during seasonal change or in adverse weather conditions
When humidity is high or there is fog, with temperatures ≥15 ° C, but also during the transitional period between seasons, it is
recommended to light a test fire before normally lighting the woodstove. This will displace the cold, heavy air that is inside the flue and
create the right conditions for optimum smoke dissipation.
6.4. Ventilation kit (optional)
ARTE® PHOENIX woodstoves can also be installed with a hot air ventilation motor o the back of the device. This feature is necessary if you
want to distribute the heat of the stove to the room or even the whole house. By blowing hot air, the ventilation kit lets you increase the heat
radiation output of the stove.
Under no circumstance should you operate the woodstove with the main
door open. You run a serious risk of destroying the device.
WARNING!!!
DO NOT cut or remove the grounding prong from the plug.
DO NOT place the power cord beneath the heater.
Although the ventilation kit is delivered ready to be installed,
it must be connected to the power grid and grounded in
accordance to local regulations ONLY by qualified personnel.
If you want to import air from an external source, you must apply the corresponding 100mm
diameter collar and clamps to mount a flexible conduit.