INSTALLATION & USER MANUAL ENERGY EFFICIENT WOODSTOVE | PHOENIX
5 | Page
3. ENDORSEMENTS & CERTIFICATIONS
3.1. Endorsement
The ARTE® wood stove you chose has been tested according to EN13229.
3.2. Declaration of Performance CE
The constructor G. Karnoutsos & Co. declares that ARTE® wood stoves meet the requirements of the standard EN 13240, also the product’s
performance according to the quality specifications are monitored on a permanent basis.
3.3. Features marking plate
ARTE® wood stove’s feature marking plate is located on the right side of the appliance.
4. PACKAGING
ARTE® is devoted in protecting the environment, so we use as much recyclable materials as possible and the least amount of packaging
materials without compromising the secure transfer of our products.
4.1. Unpacking the stove
1. The product is delivered on a wooden palette. (Pic. 4.1.1)
2. Carefully remove the plastic membrane and the waterproof plastic film and also all the styrofoam on the outside and inside of the
product.
3. Remove the styrofoam that is on the upper part of the baffler and also in the combustion chamber and the ashtray, including any other
components. (Pic. 4.1.2)
4. Unscrew the 4 screws located on the bottom side of the product, in order to release the stove from the palette. (Pic. 4.1.3)
5. Carefully pick up the product and place it on the installation point, making sure that the floor can withstand the weight of the device. If
the existing construction cannot withstand the weight of the device, a load distributing plate is necessary. Also, make sure you provide
proper insulation in case the floor is built using flammable materials.
Pic. 4.1.1
Pic. 4.1.2
Pic. 4.1.3
STYROFOAM
To Next Page
Loading...
