42
General Messages
Most messages and alerts will appear at the bottom of the normally used screens.
Several alerts and messages may be displayed in sequence. Some messages can be
reset from the panel. Messages that can be reset will appear with a “right arrow” at the
end of the message. This message can be selected by navigating to it and pressing the
select button.
– – – F – – – C
Water Temperature is Unknown
After the pump has been running for 1 minute the water temperature will be displayed.
Possible Freezing Condition
A potential freeze condition has been detected. All water devices are activated. In some
cases, the pump may turn on and off and the heater may operate during Freeze
Protection. This is an operational message, not an error code.
*M0XX is a Message Code. Codes like this will be seen in the Fault Log.
The Water is Too Hot – M029*
The system has detected a spa water temperature of 110 °F (43.3 °C) or more, and spa
functions are disabled. System will auto reset when the spa water temperature is below
108 F (42.2 C). Check for extended pump operation or high ambient temperature.
During the warmer months, changing the filter cycle is recommended to prevent the spa
from overheating with the high ambient temperature.
The Water Level is Too Low
This message can only appear on a system that uses a water level sensor. It appears
whenever the water level get too low (or the water level sensor is disconnected), and
automatically disappears when the water level is adequate. Pumps and the heater turn
OFF when this message appears.
To Next Page
Loading...
