Universal DrillSaw Battery Charger User’s Guide
DFU-0256-1 Rev. 0 Page 2 of 35
9. The equipment is NOT suitable for use in potentially explosive atmospheres or
with potentially explosive mixtures of anesthetic substances containing oxygen or
nitrous oxide.
10. DO NOT use the system without a blank shipping cover or a charger cup present
over each of the four charging bays, as this could introduce an electric shock
hazard by exposing you to dangerously high voltages or other risks.
The PRECAUTION! symbol identifies methods and procedures that
must be followed to avoid damaging the device or causing it to
malfunction.
1. DO NOT – under any condition, or for any reason – open the charger, any
system component, or any other system accessory.
2. Only use replacement power cords that meet medical grade standards
according to IEC 60320-1 Subclause 3.21, Detachable Power Supply Cords or
electrical standards for the designated country where the AR-400UBC is being
used. Contact your Arthrex representative for further information.
3. This device has passed testing for EMI / RFI radiation and susceptibility, and
EMC compatibility. This device may cause interference with other devices in the
near vicinity if not set up, and used as instructed by Arthrex.
4. DO NOT clean the device with abrasive cleaning or disinfectant compounds,
solvents, or other materials that could scratch or damage the device.
5. Always comply with the instructions issued by the manufacturer of disinfectant.
6. NEVER use liquid to clean the accessory device connector contacts. Remove
dust regularly with dry compressed air.
To Next Page
Loading...
Need help?
General
