By turning the Rate knob, you can step through the sequence and edit the modulation tracks.
The note stored in a step will trigger/sound when you pass over a step, and the modulation
stored with that step will be performed. This helps to remember where you are and what
you've created so far. If necessary, you can change the modulation stored in a step by
turning the corresponding knob. You can also press the Oct | Mod button to navigate through
active modulation tracks.
You can record events from:
Knob Function
Oscillator Type modulates the type of the currently selected oscillator
Oscillator Wave modulates the wave of the currently selected oscillator
Oscillator Timbre modulates the timbre of the currently selected oscillator
Oscillator Shape modulates the shape of the currently selected oscillator
Filter Cutoff modulates the cutoff frequency of the filter
Filter Resonance modulates the bandwidth of the filter
Envelope Attack modulates the attack stage of the Standard envelope
Envelope Decay modulates the decay stage of the Standard envelope
Envelope Sustain modulates the sustain stage of the Standard envelope
Envelope Filter Amt modulates the amount of signal sent from Envelope to Amp
LFO Rate modulates LFO rate
Cycling Envelope Rise modulates the rise stage of the Cycling Envelope
Cycling Envelope Fall modulates the fall stage of the Cycling Envelope
Cycling Envelope Hold modulates the hold stage of the Cycling Envelope
Cycling Envelope Amt amount of CycEnv sent to the Matrix
Matrix Modulation Amt Sets the modulation amount of a Matrix point
Glide Glide amount
Note: It is not possible to assign SHIFT + Knob parameters such as the Shape of the Cycling
Envelope stages. Neither can you assign control buttons (Shift, Amp | Mod LFO Mode) or icon
buttons (Spice, Dice, etc.)
The Rate knob
Arturia - User Manual MicroFreak - The Sequencer 78
To Next Page
Loading...
