Overview
Chapter 1
6 Aruba 200 Mobility Controller 0500215-01
Installation Guide January 2006
Power Input Socket (on Rear)
The power input socket on the chassis rear panel accepts the DC connector from
the power adapter (included) which connects to a power cord which you plug in
to site power. For proper safety and performance, use the power cord shipped
with the Aruba 200 Mobility Controller.
N
OTE: Use the power adapter supplied with the Aruba 200 Mobility Controller.
Do not substitute power adapters designed for other products as this
may damage the device or the power adapter.
Rubber Mounting Feet
Four rubber mounting feet stabilize and prevent slippage for placing the Aruba
200 on a flat surface. (The mounting feet are included but must be attached by
the user.)
5
6
To Next Page
Loading...
