Installing the Chassis
Chapter 2
8 Aruba 200 Mobility Controller 0500215-01
Installation Guide January 2006
Precautions
Installation Requirements
This section describes requirements for the installation of the Aruba 200 Mobility
Controller.
Location
The Aruba 200 Mobility Controller, like other computing devices and office
equipment, requires an “electronics friendly” environment. Because it can be
mounted on any flat, stable surface, select a location where the power and
network connections will not interfere with traffic and office activities.
Space
For proper air circulation, leave at least 10 cm (4 inches) clearance for the vents
on the left and right of the chassis.
Leave additional space in front and back of the chassis to access power cords,
network cables, and indicator LEDs.
CAUTION: Never insert foreign objects into the chassis or any other
component, even when the Aruba 200 Mobility Controller
is unpowered or unplugged.
Power is fully disconnected from the Aruba 200 Mobility
Controller by unplugging the power cord from the power
outlet. For safety reasons, verify the power outlet and plug
are within easy reach of the operator.
To minimize electrical hazard, keep water and other fluids
away from the product.
Comply with electrical grounding standards.
Do not ship or store this product near strong
electromagnetic, electrostatic, magnetic, or radioactive
fields.
Do not disassemble the chassis. This product has no
internal serviceable parts. When service or repair is
needed, see “Contacting Aruba Networks” on page x.
To Next Page
Loading...
