TD 92232GB
2005-06-15 / Ver.G
Installation Guide
ELISE2
21
8 Change the default passwords for all users. If the passwords are not changed,
anyone with knowledge of the default passwords can access your ELISE2 module
and change any parameter.
9 Set all sections in SW3 to OFF. Reboot ELISE2 by navigating to "Reboot".
10 Return to the program "Route to ELISE" and press "Detach" to remove the ELISE2
network setup IP address from the route table. Close the program.
11 When ELISE2 has been restarted, enter the URL xxx.xxx.xxx.xxx/admin in your
browser (xxx.xxx.xxx.xxx is the IP address that was given to ELISE2 during network
setup) and see that it has started up correctly.
12 If an entry is added in the DNS, it will be easier to connect to ELISE2.
To Next Page
Loading...
