26
4 - Operations
4.6 CONFIGURATION
The configuration of the controller
is specified through a 4 digit code
that defines the type of input, of
control output and of the alarms.
(sect. 3.2 pag16)
Other parameters specifie the type
of auxiliary functions.
Press S or G to display the next
parameter or the next code and
change its value.
The new value entered is stored
into the controller when the next
parameter is selected by pressing
R.
1
2
AT
Values
modification
Modification/
Selection
enter
Parameter
menu
selection
OK
274.8 PASS
5000
AIs.p
sc.lo
prot
sc.Hi
retr
baud
Code
CONFIGURATION MENU
1st GROUPOperator mode
Low range [2]
(linear scale only)
-999…9999
High range [2]
(linear scale only)
-999…9999
Communication protocol
(only if communication is
installed)
M.bu5 / jbus
Baude rate
(only if comm. is installed)
1200/2400
4800/9600
Retransmission range
(only if present)
0=20 / 4=20 mA
Password [3]
0…9999
(
33 default from factory)
YESNO
Password entry
only if
Code
value ≥5000
Code entry
from 5000 to 9999
Must be equal
to the value of the
parameter
Code
M1UK.ed5 14-05-2009 14:56 Pagina 26
To Next Page
Loading...