Forces the device restart. The command ensures a complete initiali-
zation of all internal electronics and software. The visual feedback of
the operation is returned by the RESET LED.
Restores the Ubiquity Router device to factory settings. All the set-
tings are reset, all the system software is restored to original ver-
sions including the operating system, the firmware the Ubiquity
Runtime and Domain registrations (identity is removed).
To execute the restore, turn off the device, press and hold down the
reset button and give power.
You need to hold down the button for at least 10 seconds. The start-
ing of the restore process is indicated by the dedicated blink se-
quence of the LEDs.
Wait for the process to be completed and system restart.
To Next Page
Loading...
Need help?
General
