PAGE 15
PAD SETTINGS
ABOUT THE DRUM KITS
If the digital drum is not yet in UTILITY menu, press the [UTILITY] button to enter it.
The UTILITY indicator will light up. You can use the [–] or [+] buttons to adjust parameters
(as shown to the right ) for each pad as well as the rim sensitivity of the pad and the
splash sensitivity of the Hi-Hat control pedal.
The current pad to be edited can be selected either by pressing its Pad Select button,
or by striking the pad itself. The PAD indicator will light up to show which pad is currently
selected. If the rim of a pad is selected, both the PAD indicator and the RIM indicator will
turn on.
ADJUSTING PAD SENSITIVITY
1. Press the [PAGE] or [UTILITY] button, select Pad Sensitivity page. The display will show:
2. Change how a pad responds to your playing. At higher sensitivities, the pad will
generate a louder signal, even when you play softly. At lower sensitivities, the pad will
generate a quieter signal, even if you play strongly. Adjust according to your playing
style and desired dynamic range.
SETTING PAD THRESHOLD
1. Press the [PAGE] or [UTILITY] button, select Pad Threshold page. The display will show:
2. Change how forcefully you must strike the pad to generate a trigger signal. Setting
a high threshold requires hitting the pad very hard to get a sound. This can help cut
out transient responses, such as vibrations from the kit or accidental pad taps that
you don’t intend to generate. Setting a low threshold means even light touches will
produce sound. Adjust according to environment and playing style.
ELIMINATE PAD CROSSTALK
1. Press the [PAGE] or [UTILITY] button, select Pad Crosstalk page. The display will show:
2. When two pads are mounted close to each other, hitting one pad may trigger the
sound from another pad unintentionally. This effect can be eliminated by setting this
parameter to a higher value on the pad.
1
1
2
2
2
1
To Next Page
Loading...