Note
Smart probes use their own internal calibration data. The
instrument coefficients are ignored when a Smart probe is
attached.
Only channel A operation will be covered (channel A and channel B operate identically). Press the
Enter k ey to select the sub-menu. Note that the sub-m enu will be different for Smart and Passive
probes.
The Channel sub-menu is used to review the information about the Smart Probe and to review the
coeffic ients used by the Smart probe.
Press the Enter key to select Smart probe
information. T he display will look similar to the
one shown.
The values held by the Smart probe are
displayed. Use the Up/Dn keys to display more
of the values held within the probe. Refer to the
section on Smart probes for further details; the
SMP Coefficient Menu is covered in section 4.1.2.
4.1.3.3 Channel options menu (Channel A or Channel B) – Passive probes
Only channel A operation will be covered (channel A and channel B operate identically). Press the
Enter key to select the sub-menu. Note that the sub-menu will be different for Passive and Smart-
probes.
The Channel sub-menu is used to change the information about the Passive probe.
8Q LW V
8Q LW V8Q LW V
8Q LW V
&K DQ QH
&K DQ QH&K DQ QH
&K DQ QH O $
O $O $
O $
&K DQ QHO%
&K DQ QHO%&K DQ QHO%
&K DQ QHO%
/R JJ LQJ
/R JJ LQJ/R JJ LQJ
/R JJ LQJ
6W DW LVWLF V
6W DW LVWLF V6W DW LVWLF V
6W DW LVWLF V
6H WW LQJV
6H WW LQJV6H WW LQJV
6H WW LQJV
6\ VW HP
6\ VW HP6\ VW HP
6\ VW HP
60 3 3UREH , QI R
60 3 3UREH , QI R60 3 3UREH , QI R
60 3 3UREH , QI R
60 3 &RHII LF LH QWV
60 3 &RHII LF LH QWV60 3 &RHII LF LH QWV
60 3 &RHII LF LH QWV
To Next Page
Loading...