√1 adapter “B”for natural or city gas
√1adapter“C”for L.P.G.
√gaskets “D”,“E”and“F”
The hob must be installed in a room with adequate
ventilation(see page 13).
Gas connection for:
Natural gas (G20)or city gas (G110)
√Remove the adapter“C”using two spanners.
√Connect the cooking hob to the gas net by a suitable rubber
tube(inside diameter 13 mm).
L.P.G.(in cylinders)G30
√Fit up the adapter “C”to the adapter “B” interposing
gasket“E”.Tighten using two spanners.
√Connect the cooking hob to the cylinder pressure regulator by a
suitable rubber tube (inside diameter 8 mm).
Make sure the tube is snugly fit at both ends and use a standard
tube clamp (not supplied) to fasten it.
Orientation of the elbow
The appliance is supplied with a gas connection oriented towards
the centre of the cooking hob. The connection to the gas supply
must be effected only from this side or in vertical position by
turning the elbow downwards.To turn the elbow, follow these
operations:
√Ioosen the nut
√turn the elbow
√lock the nut
√make sure that there are no leakages by a soapy solution
]IMPORTANT:
To Next Page
Loading...