√Never attempt to turn the elbow “A”without having first
slackened off the relative lock nipple.
√The seals“D-E-F”(fig.18) are the elements that guarantees the
seal in the gas connection.
Is is recommended that they be replaced whenever they shows
even the slightest deformation or imperfection.
√After connecting to the mains, check that the couplings are
correctly sealed, using soapy solution,but never a naked flame.
√The connection with rigid metal pipes should not cause stresses
to the bob ramp.
√If the rubber tube is used for the gas connection:
-Make sure the tube is snugluy fit at both ends and use a
standard tube clamp (not supplied)to fasten it.
-The rubber tube must be as short as possible, without
contractions or kinks.
-The rubber tube must never be at any point in its length in
contact with the “hot” parts.
-From time to time check to make sure that the rubber is in
perfect condition and
OPERATIONS TO BE PERFORMED WHEN SUBSTITUTING
THE INJECTORS
If the injectors are not supplied they can be obtained from
the “Service Centre”.
√Remove the gratings and the burner covers;
√Using a wrench,substitute the nozzle injectors。“J”(Fig.20) with
those most suitable for the kind of gas for which it is to be used
(see Injector table).
The burners are conceived in such a way so as not to require the
regulation of the primary air.
To Next Page
Loading...