Assa Abloy ACCENTRA 8800 Series - Page 3

8800 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
3
80-8800-0017-000 04/24
Copyright © 2023,2024 ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
3. Lock Set Conguration
To re-hand lock, see instructions on lock body.
4. Rehanding Indicator (If required)
Verify hand and bevel of door (Figure 2).
Figure 2
LH
Left Hand
Hinges Left
Open Inward
LHRB
Left Hand
Reverse Bevel
Hinges Left
Open Outward
RH
Right Hand
Hinges Right
Open Inward
RHRB
Right Hand
Reverse Bevel
Hinges Right
Open Outward
NOTE: Stand on outside of locked door when determining door hand.
Next, verify inside and/or outside indicators are handed correctly, using
Spindle Cam Position chart (Figure 3). If they are handed correctly, skip
to Step 5 “Installation - Prepare Door”.
If they are not handed correctly:
1. Remove indicator back plate by pulling out from top slot, then
remove spindle cam from assembly (Figure 4).
2. Position spindle cam in correct direction for door hand
(Figure 3).
NOTE: For thumbturn indicators, make sure thumbturn is positioned
in the 12 o'clock direction as shown (Figure 5).
3. Slide spindle cam post into correct slot of display slide
(Figure 4).
4. Re-seat back plate into original position.
5. Return indicator to the vacant/unlocked position for installation.
Door Hand RH/RHRB
Figure 3
Spindle Cam Position for Locks with Deadbolt
(*Includes 8864 function)
Outside Indicator
Inside Indicator
Door Hand LH/LHRB
Inside Indicator
Outside Indicator
Spindle Cam Position for Locks without Deadbolt
(*Does not include 8864 function)
Door Hand RH/RHRB
Inside Indicator
Outside Indicator
Door Hand LH/LHRB
Outside Indicator Inside Indicator
Spindle Cam
Backing Plate
Thumbturn
Position
Figure 4
Figure 5