8800 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
4
80-8800-0017-000 04/24
Copyright © 2023,2024, ASSA ABLOY ACCENTRA™ Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1-855-557-5078 Ext. 2 • www.accentra-assaabloy.com
5. Installation
1. Prepare Door for Mortise Lock
Prepare door for function holes, size, and location according to 7088-
0005 door marker template, if not already prepped.
2. Install Lock
1. Verify strike location according to template. Clean out door pocket
and door edge of debris.
2. Make sure handing of lock matches handing of door. Slide lock into
door (Figure 6).
3. Temporarily hand tighten two (2) lock screws (#12 x 1-1/4" wood
screws, or #12-24 x 1-1/2" machine screws).
NOTE: Keep door open until installation is complete.
3. Install Outside Trim
1. Verify lock is in unlocked state (square control hub slot should be
oriented as a diamond).
2. Unscrew the inside spindle from the outside lever assembly 1/2 turn
and align the ramp in the horizontal position before inserting into
the lock.
3. Slide outside escutcheon assembly on door and insert outside
lever assembly and plastic bushing into lock body. Lever must be
horizontal (Figure 7).
NOTE: If indicator is used on outside, align indicator spindle with
control hub.
Outside
Escutcheon
Assembly
Plastic Bushing
Outside Lever
Assembly
Lock
Screws
Lock
Inside of Door
Outside
of Door
RH Door
Shown
Figure 6
Figure 7
To Next Page
Loading...
