WARNINGS DISPLAY
Apart from messages displayed on the User display, there are two warning indicators.
(a) LOW SALT: This indicates that the concentration of salt has reduced within you pool. To rectify, add salt at
approx. 50kg per 50000 litres of water (see 3.5 Salt level below)
(b) NO FLOW: This indicates that the Chlorinator thinks that there is no flow to the cells. Potential
problems/solutions are described in the Diagnostics section.
CHLORINE OUTPUT LEVEL
The LED lights on the user panel set the desired output level or chlorine level.
As shown below, the bottom right hand corner of the LCD display indicates the actual level as distinct from the set or
desired output indicated by the LED lights.
The chlorinator output, or chlorine production, will be affected by water temperature, salt levels and the input voltage of
the chlorinator. When the chlorinator is operating at maximum efficiency, the Chlorine Output level should always be
approximately the same level as the Set Point. The set point can be checked on the LED display which is divided into 8
sections. If all 8 LEDs are illuminated, our set point is at 8. If only 6 lights are illuminated, the set point is 6.
Your VX Salt chlorinator will always attempt to adjust the output so that the actual output level matches set point level. At
times when the Chlorine output level is lower than the set point, check the salt level in your swimming pool at your local
pool shop. Alternatively, you may have a low voltage supply to the chlorinator (less than 240Volts) or the water may be
colder than usual.
Maximum efficiency will be achieved from you chlorinator at the following levels
Water at 27° C
Voltage at 240V
Salt Level at 4000 PPM
To Next Page
Loading...
