6
2
LAN LED
Off: No power or no physical connection.
On: Has physical connection to a local area network (LAN).
3
WAN LED
Off: No power or no physical connection.
On: Has physical connection to a wide area network (WAN).
4
5GHz LED / 2.4GHz LED
Off: No 5GHz or 2.4GHz signal.
On: Wireless system is ready.
Flashing: Transmitting or receiving data via wireless connection.
5
Power LED
Off: No power.
On: Device is ready.
Flashing slow: Rescue mode
Flashing quick: WPS is processing.
6
USB 2.0 ports
Insert USB 2.0 devices such as USB hard disks or USB flash drives into these ports.
Insert your iPad’s USB cable into one of these ports to charge your iPad.
7
Reset button
This button resets or restores the system to its factory default settings.
8
LAN 1 ~ 4 ports
Connect network cables into these ports to establish LAN connection.
Yellow LED: 1000Mbps connection.
Green LED: 10Mbps/100Mbps connection.
Flashing: Transmitting or receiving data via wired connection.
9
WAN (Internet) port
Connect a network cable into this port to establish WAN connection.
Yellow LED: 1000Mbps connection.
Green LED: 10Mbps/100Mbps connection.
Flashing: Transmitting or receiving data via wired connection.
10
Power (DC-In) port
Insert the bundled AC adapter into this port and connect your router to a power
source.
11
WPS button
This button launches the WPS Wizard.
To Next Page
Loading...
