Asystems NT2508 - Specifications

14
NT2508 / NT2504 / NT1308 / NT1304 / NT4004
English
SPECIFICATIONS
NT1304 NT1308 NT2504 NT2508 NT4004
Low Z, Stereo Mode, all channels driven (RMS Power Ouput Per Channel)
8Ω, 20Hz-20kHz 1%THD
80W 80W 150W 150W 250W
4Ω, 20Hz-20kHz 1%THD
130W 130W 250W 250W 400W
Low Z, Bridge Mode, all channels driven (RMS Power Output)
8Ω, 20Hz-20kHz 1%THD
260W 260W 500W 500W 800W
Distributed Output (RMS Power Output Per Channel)
70V, 100V, 20Hz-20kHz 1%THD
130W 130W 250W 250W 400W
Models Available 4Ω and 8Ω / 70.7V Constant Voltage / 100V Constant Voltage
Please consult your sales assistant for information on ordering the model that is
best for you
System Amp Circuitry D
Input Sensitivity 1�42 Vrms
Distortion (SMPTE-IM) <0�02%
Noise (Unweighted 20
Hz - 20 kHz below rated
power)
107 dB
Damping Factor >300 @ 8Ω
Frequency Response 20 Hz-20kHz +-1dB; -3dB: 5Hz-50kHz
Input Impedance 20 kΩ balanced; 10 kΩ Unbalanced
Cooling Variable Speed Fans - front to rear ow
Indicators
-10dB,-20dB, Signal, Peak, Bridge (one per two-channel group), Power,
Protection, Power O󰀨
Front Panel AC power switch & gain control
Control Operation Mode Stereo / Bridge Mono
Voltage Gain 40 x (32 dB)
Network Control Built-in Ethernet, 10/100 Mbit/s
Connections Input 4 x 3-pin
Euroblock
Connectors
8 x 3-pin
Euroblock
Connectors
4 x 3-pin
Euroblock
Connectors
8 x 3-pin
Euroblock
Connectors
4 x 3-pin
Euroblock
Connectors
Output 4 x 3-pin
Euroblock
Connectors
8 x 3-pin
Euroblock
Connectors
4 x 3-pin
Euroblock
Connectors
8 x 3-pin
Euroblock
Connectors
4 x 3-pin
Euroblock
Connectors
Protection
Circuitry
Amplier Protection
Totally Short / Open / Overheat / VLF / RF protection / Mismatched loads stabilize
the transition
Load Protection On / O󰀨 squelch / AC coupling / Triac crowbar (each channel)
Power Supply
Power Consumption 180W 400W 375W 750W 600W
Power Requirements
(Region Dependent)
100 - 120VAC, 220 - 240VAC, 50/60Hz