Atag DW7114XT - User Manual

Questions and Answers

D
Danielle BrooksAug 23, 2025
How do I fix water remaining in my Atag DW7114XT?
- L
  lisaelliottAug 23, 2025
  If water remains in your Atag Dishwasher after a cycle: * Clean the coarse and fine filters, as they may be blocked. * Ensure the filters are correctly fitted and the filter handle is locked in the stop position. * Clean any debris from the drainage pump. * Check that the colored stop on the right in the bottom drain is in place. * Make sure the drainage hose is free from kinks and sharp bends. * Check the drainage hose connection to the sink unit's water trap for blockages, ensuring it has an inner diameter of at least 14 mm.
M
Mitchell MartinAug 26, 2025
Why can't I close the door of my Atag Dishwasher?
- M
  Marissa CurtisAug 26, 2025
  You may not be able to close the door of your Atag Dishwasher because: * The baskets are not correctly positioned. Ensure they are correctly positioned horizontally. * The door lock isn't clicking into place. Check the door lock. If it doesn't click, open the door, press and hold the left navigation button and the Auto Open option button until the display starts flashing (about 60 seconds). Then, close the door again and check if the lock clicks.
W
Wesley MurphyAug 28, 2025
What to do if my Atag DW7114XT buttons do not react?
- M
  Mallory RileyAug 28, 2025
  If the buttons on your Atag Dishwasher aren't responding, here's what to do: * Wait a moment and try again, especially if you've just opened the door. * Check if the child lock is activated. Refer to the Settings chapter for deactivation instructions. * Ensure the door is open. The buttons only work when the door is open. * Clean the buttons with a dry or slightly damp cloth, as they may be dirty.
J
Jason KennedyAug 30, 2025
How to get my Atag DW7114XT dishes dry enough?
- A
  Amber RodriguezAug 31, 2025
  If your dishes aren't drying properly in your Atag Dishwasher: * Activate the Auto Open option. * Make sure you fully load the dishwasher. * Top up the rinse aid or increase the rinse aid dosage level. Refer to the Settings chapter for instructions. * If you're using all-in-one detergents and the drying is poor, switch to separate detergents, deactivate the setting TAB, and add salt and rinse aid. See the Rinse aid section in the Settings chapter.
J
James RomeroSep 4, 2025
How to prevent spots on stainless steel or silver in my Atag DW7114XT?
- J
  James DeleonSep 4, 2025
  To prevent spots on stainless steel or silver in your Atag Dishwasher: * Rinse off foods like mustard, mayonnaise, lemon, vinegar, salt, and dressings from dishes if you're not starting the dishwasher immediately. Use the Rinse and hold program. * Separate dishes made from different metals, such as silver, stainless steel, and aluminum, to avoid contact during washing.
C
Craig PerrySep 6, 2025
What causes a bad odour in my Atag DW7114XT and how to fix it?
- A
  Alyssa VazquezSep 6, 2025
  A bad odor in your Atag Dishwasher can be caused by: * Dirt around the seals and in corners. Clean these areas with a washing-up brush and low-foaming cleaner. * Prolonged use of low-temperature programs. Run a program with a high temperature once or twice a month, or use a self-cleaning program. See Self-cleaning in the chapter Using the dishwasher.
M
Marissa MoralesSep 9, 2025
How do I remove grease deposits in my Atag DW7114XT?
- K
  Keith MurraySep 9, 2025
  Grease deposits in your Atag Dishwasher are often due to: * Using low-temperature programs for extended periods. Select a program with Intensive mode, which uses a higher temperature to dissolve grease on very dirty dishes. Alternatively, run a self-cleaning program once or twice a month. See Self-cleaning in the chapter Using the dishwasher.
D
David LewisSep 12, 2025
Why is there detergent residue in the detergent compartment of my Atag DW7114XT Dishwasher after washing?
- N
  nicholas29Sep 12, 2025
  Detergent residue in the compartment of your Atag Dishwasher after washing can occur if: * The detergent compartment was damp when you added the detergent. Ensure the compartment is dry before adding detergent. * The detergent compartment has been blocked. Check that dishes are not preventing the detergent compartment from opening.
E
Edward JohnsonSep 13, 2025
What causes a rattling sound when dishwashing in my Atag Dishwasher?
- M
  marcdavisSep 13, 2025
  A rattling sound during dishwashing in your Atag Dishwasher usually means: * The dishes are not correctly placed, or the spray arms are not rotating. Make sure the dishes are placed securely. Spin the spray arms to ensure they can rotate freely.
M
Melissa WoodSep 15, 2025
What causes the sticky white/blue film on dishes from my Atag Dishwasher?
- E
  Erica WoodsSep 15, 2025
  A sticky white or blue film on dishes from your Atag Dishwasher indicates: * The rinse aid dosage is set too high. Reduce the dosage. Refer to the Settings chapter. If you have very soft water, consider diluting the rinse aid 50:50 with water.