Atag DW7214MB - User Manual

Questions and Answers

J
Joann BrownAug 18, 2025
Why won't my Atag DW7214MB start?
- M
  Morgan WatersAug 18, 2025
  Your Atag Dishwasher might not start due to several reasons: * The display may not show "Program started", in this case press until it does. * The door may not be properly closed, so check it. * If you opened the dishwasher mid-cycle, close the door and wait for it to continue. * The door lock may not be engaged; check the door lock, press and hold until the display flashes, wait 60 seconds, and then close the door again. * The delayed start option might be active; press and hold for three seconds to cancel it. * The plug might not be in the wall socket, so check it. * A fuse/circuit breaker may have tripped, so check it.
A
alicia88Aug 20, 2025
What to do if water remains in my Atag DW7214MB Dishwasher?
- M
  Mr. Kevin Navarro Jr.Aug 20, 2025
  If water remains in your Atag Dishwasher, try the following: * Clean the coarse and fine filters. * Check that the filters are fitted correctly. * Clean the drainage pump. * Check that the yellow drainage pump stop is in place. * Ensure the drainage hose is free from kinks and sharp bends. * Check the drainage hose connection to the sink unit's water trap for blockages, ensuring it has at least a 14 mm inner diameter.
L
Louis WilliamsAug 23, 2025
How to fix spots or films on dishes from Atag DW7214MB?
- M
  Matthew RichardAug 23, 2025
  To address spots or films on dishes from your Atag Dishwasher: * Adjust the rinse aid dosage setting. * If using all-in-one detergent with the TAB setting activated, switch detergents or deactivate the TAB setting and add salt and separate rinse aid. * Refill the salt compartment if empty. * Adjust the water softener setting. * Check the salt compartment lid for tightness. * If etching occurs on crystal, wash at a lower temperature with less detergent.
D
duffydawnAug 26, 2025
How to prevent spots on stainless steel or silver in my Atag DW7214MB Dishwasher?
- D
  Derek ShahAug 26, 2025
  To prevent spots on stainless steel or silver in your Atag Dishwasher: * Rinse off food items like mustard, mayonnaise, lemon, vinegar, salt, and dressings promptly, or use the Rinse and hold program. * Separate silver, stainless steel, and aluminum dishes to avoid contact during washing.
C
charles47Aug 27, 2025
How to fix Atag DW7214MB dishes not drying?
- Y
  yromeroAug 28, 2025
  If your Atag Dishwasher isn't drying dishes adequately: * Activate the Auto door open option. * Ensure the dishwasher is fully loaded. * Top up the rinse aid or increase its dosage. * If using an all-in-one detergent with the TAB setting activated, switch to separate detergents or deactivate the TAB setting and add salt and rinse aid separately.
T
Thomas LarsenAug 30, 2025
How to get rid of bad odour in my Atag Dishwasher?
- S
  smithgaryAug 30, 2025
  To eliminate bad odors in your Atag Dishwasher: * Clean around the seals and in corners with a washing-up brush and low-foaming cleaner. * Run a high-temperature program or a self-cleaning program once or twice a month, especially if you typically use low-temperature programs.
A
Alyssa MaloneSep 1, 2025
How to remove grease deposits in my Atag DW7214MB?
- D
  Donna WilsonSep 2, 2025
  To remove grease deposits from your Atag Dishwasher, select a high-temperature program for very dirty dishes, such as Intensive. Alternatively, run a self-cleaning program once or twice a month.
E
Erin CraigSep 4, 2025
How to remove sticky white/blue film from dishes in my Atag DW7214MB Dishwasher?
- L
  Lauren PerezSep 4, 2025
  If your dishes have a sticky white/blue film after washing in your Atag Dishwasher, the rinse aid dosage setting may be too high. Reduce the dosage. If you have very soft water, you may want to dilute the rinse aid 50:50 with water.
R
Robert EstradaSep 6, 2025
How to remove spots left after washing in my Atag Dishwasher?
- C
  Crystal CollinsSep 7, 2025
  To remove spots left after washing in your Atag Dishwasher, especially from lipstick and tea, use a detergent with a bleaching agent.
T
Terry SmithSep 9, 2025
What to do if my Atag Dishwasher door won't close?
- L
  Lindsey SpencerSep 9, 2025
  If you're having trouble closing the door of your Atag Dishwasher: * Check that the baskets are correctly positioned horizontally. * If the door lock isn't clicking into place, open the door, press and hold until the display starts flashing, wait until it stops (60 seconds), then close the door again.

Atag DW7214MB Specifications

General

Type	Freestanding
Energy Efficiency Class	A++
Number of Place Settings	14
Noise Level	44 dB
Water Consumption	9.5 L
Programs	8
Drying Class	A
Delay Start	Yes
Half Load Option	Yes
Child Lock	Yes
Dimensions (H x W x D)	85 cm x 60 cm x 60 cm
Annual Water Consumption	2660 L