Atag DW7114OXB - User Manual

Questions and Answers

M
Michael LeeAug 22, 2025
What to do if my Atag DW7114OXB buttons do not react?
- B
  benjamin09Aug 22, 2025
  If the buttons on your Atag Dishwasher aren't responding, here are a few things to try: * If you've just opened the door, wait a moment before pressing the buttons again. * Check if the child lock is activated; if so, refer to the Settings chapter for deactivation instructions. * Ensure the door is open, as the buttons only respond when it is. * Also, the buttons might be dirty; clean them with a dry or slightly damp cloth.
M
Michael SchmidtAug 28, 2025
How to prevent water from remaining in my Atag Dishwasher?
- C
  Christian FarmerAug 28, 2025
  If water is left in your Atag Dishwasher after a cycle, check the following: * The filters might be blocked; clean the coarse and fine filters. * The filters may not be correctly fitted; ensure the filter handle is locked in the stop position. * There could be debris in the drainage pump; clean the drainage pump. * The drainage pump stop might be missing; check that the colored stop on the right in the bottom drain is in place. * The drainage hose may have a kink; ensure it's free from kinks and sharp bends. * The drainage hose could be blocked; disconnect it from the sink unit's water trap and check for debris, ensuring the connection has an inner diameter of at least 14 mm.
R
rfergusonAug 30, 2025
How to eliminate bad odors in my Atag DW7114OXB?
- B
  ballardlarryAug 30, 2025
  To get rid of bad odors in your Atag Dishwasher: * Clean dirt around the seals and in the corners using a washing-up brush and a low-foaming cleaner. * If you've been using low-temperature programs for a while, run a high-temperature program once or twice a month.
M
Mary Martinez MDSep 1, 2025
Why are my dishes not dry enough in Atag DW7114OXB?
- L
  lkimSep 1, 2025
  If your dishes aren't drying properly in your Atag Dishwasher, consider these points: * Ensure the Auto Open option is activated. * Make sure the dishwasher is fully loaded. * Check the rinse aid level and dosage; top up if necessary or increase the dosage level. * If using all-in-one detergent with the TAB setting activated, it might not provide sufficient drying; try switching detergents or deactivating the TAB setting and using separate rinse aid.
H
harrissamanthaSep 3, 2025
What causes grease deposits in my Atag DW7114OXB?
- D
  David RamosSep 3, 2025
  Grease deposits in your Atag Dishwasher often result from using low-temperature programs for extended periods. Try running a high-temperature program, such as the Intensive program, to dissolve the grease.
N
Noah CoxSep 6, 2025
What causes spots on stainless steel or silver in my Atag DW7114OXB?
- J
  joseandersonSep 6, 2025
  Spots on stainless steel or silver in your Atag Dishwasher can be caused by: * Certain foods like mustard, mayonnaise, lemon, vinegar, salt, and dressings, if left on dishes for too long. Rinse these off before washing or use the Rinse & hold program. * Contact between different metals (stainless steel and silver, or aluminum) during washing. Separate dishes made from different metals to avoid marks and tarnishing.
S
Susan ClineSep 8, 2025
What to do if my Atag DW7114OXB door won't close?
- A
  Alex GutierrezSep 8, 2025
  If you're having trouble closing the door of your Atag Dishwasher: * Check that the baskets are correctly positioned horizontally. * If the door lock isn't clicking into place, open the door, press and hold the navigation and Auto Open buttons until the display flashes, wait 60 seconds, then close the door and check the lock again.
A
anne60Sep 10, 2025
How to fix a rattling sound when dishwashing in my Atag Dishwasher?
- T
  Trevor HeathSep 10, 2025
  A rattling sound during dishwashing in your Atag Dishwasher usually means that the dishes are not correctly placed, or the spray arms are not rotating. Ensure the dishes are placed securely and spin the spray arms to check their rotation.
A
Aimee MasonSep 12, 2025
Why is there detergent residue in the compartment of my Atag DW7114OXB?
- J
  jeff15Sep 12, 2025
  Detergent residue in the detergent compartment of your Atag Dishwasher could be due to: * The compartment being damp when you added the detergent; make sure it's dry. * The compartment being blocked by dishes; check that nothing is preventing it from opening.
C
Christopher StevensonSep 14, 2025
What causes a sticky white or blue film on dishes from Atag Dishwasher?
- D
  Dan DavisSep 14, 2025
  A sticky white/blue film on dishes from your Atag Dishwasher is likely due to a rinse aid dosage setting that is too high. Reduce the dosage. If you have very soft water, consider diluting the rinse aid 50:50 with water.