Atag DW7214OMB/A02 - User Manual

Questions and Answers

J
jonesmadisonAug 18, 2025
What to do if my Atag DW7214OMB/A02 doesn't start?
- J
  Justin FarmerAug 19, 2025
  If your Atag Dishwasher doesn't start, there are several things you can check: * Ensure the dishwasher door is properly closed. * Make sure the plug is correctly plugged into the wall socket. * Check that a fuse or circuit breaker hasn't tripped. * If you opened the dishwasher mid-cycle, close the door and wait for it to resume. * Verify that the door lock clicks into place; if not, open the door, press and hold until the display flashes, wait 60 seconds, and then close the door again. * Press until the display shows "Program started". * If you want to cancel the Delayed start option, press and hold for three seconds.
D
Daniel RamosAug 21, 2025
How to fix an Atag DW7214OMB/A02 Dishwasher that leaves dishes not clean?
- J
  jordanronnieAug 21, 2025
  If your Atag Dishwasher isn't cleaning dishes properly, consider the following: * Make sure the dishes are not blocking the spray arms. * Clean the spray arms if the holes or bearings are blocked. * Select a more intensive program for greasy dishes. * Adjust detergent dosage based on water hardness; too much or too little can affect results. * Ensure your detergent isn't old. * Load dishes correctly, avoiding overcrowding. * Ensure glasses and cups are stable. * Clean clogged coarse and fine filters, and ensure they are correctly fitted. * Check that the yellow drainage pump stop is in place.
R
Richard NorrisAug 23, 2025
What to do if water remains in my Atag DW7214OMB/A02 Dishwasher?
- M
  michael72Aug 23, 2025
  If water remains in your Atag Dishwasher, here's what to check: * Clean the coarse and fine filters. * Ensure the filters are correctly fitted. * Check for any kinks or sharp bends in the drainage hose. * Disconnect the drainage hose from the sink unit's water trap to check for blockages, ensuring the connection has an inner diameter of at least 14 mm. * Check that the yellow drainage pump stop is in place.
M
Michael JacksonAug 26, 2025
Why aren't the dishes dry enough in my Atag DW7214OMB/A02 Dishwasher?
- E
  emily96Aug 26, 2025
  If your dishes aren't drying properly in your Atag Dishwasher: * Activate the Auto door open option. * Ensure the dishwasher is fully loaded. * Top up the rinse aid or increase the rinse aid dosage setting. * If using all-in-one detergents with the TAB setting activated, switch to separate detergents or deactivate the TAB setting and add salt and rinse aid separately.
N
Nicholas FoxAug 27, 2025
How to remove spots or films on dishes from my Atag DW7214OMB/A02?
- A
  Alex HenryAug 27, 2025
  To address spots or films on dishes from your Atag Dishwasher: * Check and adjust the rinse aid dosage setting. * If using all-in-one detergent, switch to separate detergent, deactivate the TAB setting, and add salt and rinse aid separately. * Ensure the salt compartment is full. * Verify that your water softener setting is correct. * Make sure the salt compartment lid is properly tightened. * Wash crystal at a low temperature with a conservative amount of detergent.
A
Amanda FrederickAug 30, 2025
How to remove grease deposits in my Atag DW7214OMB/A02?
- J
  Jared GrantAug 30, 2025
  To remove grease deposits from your Atag Dishwasher, select a program with a high temperature to dissolve grease on very dirty dishes, such as Intensive. Or run a self-cleaning program once or twice a month.
F
Frederick RochaSep 1, 2025
How to prevent spots on stainless steel or silver in my Atag DW7214OMB/A02 Dishwasher?
- M
  Mary GarciaSep 1, 2025
  To prevent spots on stainless steel or silver in your Atag Dishwasher: * Rinse off foods like mustard, mayonnaise, lemon, vinegar, salt, and dressings if not starting the dishwasher immediately. Use the Rinse and hold program. * Separate dishes made from different metals, such as silver, stainless steel, and aluminum.
T
tracie80Sep 3, 2025
Why is there detergent residue in the detergent compartment of my Atag DW7214OMB/A02 after dishwashing?
- R
  Robin AndersonSep 3, 2025
  If you find detergent residue in the detergent compartment of your Atag Dishwasher after washing: * Make sure the detergent compartment is dry when adding detergent. * Check that the dishes are not preventing the detergent compartment from opening.
G
george02Sep 6, 2025
How to remove sticky white/blue film from dishes in my Atag Dishwasher?
- S
  Sierra BrownSep 6, 2025
  If your dishes have a sticky white/blue film after washing in your Atag Dishwasher, reduce the rinse aid dosage. If you have very soft water, you may want to dilute the rinse aid 50:50 with water.
M
matthew61Sep 8, 2025
How to remove spots left after washing in my Atag Dishwasher?
- A
  ashleyraySep 9, 2025
  To remove spots left after washing in your Atag Dishwasher, use a detergent with a bleaching agent, as lipstick and tea can be difficult to wash off.