Atag DW7214OMB/A02 - Troubleshooting

ActionError messages
Unblocking the drainage pump. See the chapter Care and
cleaning. If the problem persists, contact your nearest service
centre.
Overfilling water 1F10
See "Water remains in the dishwasher" under "Problem" in the
table below. If the problem persists, contact your nearest service
centre.
Water outlet faultF11
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Water inlet fault 1F12
Turn off the water tap and contact your nearest service centre.Inlet valve leakageF40
Turn off the water tap. Remove the plug from the wall socket and
contact your nearest service centre.
Heater fault 1F41
Contact your nearest service centre.Diverter faultF45
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, contact your
nearest service centre.
Water level faultF52
Turn off the water tap and contact your nearest service centre.Overfilling water 2F54
To avoid water leakage outside the dishwasher, do not remove
the plug from the wall socket until the water tap on the supply line
has been turned off!
Contact your nearest service centre.Circulation pump faultF56
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, contact
your nearest service centre.
Water inlet fault 2F67
Contact your nearest service centre.BLDC drain pump faultF68
Press any button to clear the error message.
ActionPossible causesProblem
Wait a moment then try again.You have pressed the control
panel too soon after opening the
door.
The control panel does not react
when pressed.
See the chapter Safety
instructions.
Child lock or Automatic child
lock is activated.
Open the door. The control
panel only reacts to use when
the door is open.
The door is closed.
Clean with a dry or slightly damp
cloth.
Dirt on the control panel.
30
Troubleshooting