EN 26
The user menu enables the user to set the signals on the hob as desired. This concerns both
audio (tone and volume) and visual signals.
1. Touch the on/off key twice within three seconds.
▷ The pause key is blinking.
2. Touch and hold the pause key.
3. Then, touch each cooking zone key clockwise (start with the cooking zone key on the front
left).
4. Release pause key.
▷ “U” is flashing alternately with a number between 2 and 7 on the cooking zone display
on the rear left.
▷ The configuration value appears in the cooking zone display on the front left.
5. Touch the cooking zone key on the rear left and choose the correct number of the menu
code ( see table).
6. Touch the cooking zone key on the front left and select the correct value (see table).
7. Confirm the setting; touch and hold the on/off key until you hear an audio signal.
USER MENU
To Next Page
Loading...
Need help?
General
