Installation & Servicing Instructions ATAG Q-Series
4
1 Introduction
These instructions describe the functioning, installation, use and primary maintenance of
ATAG central heating units for the United Kingdom and Ireland. Where necessary the
different regulations for each country are separately described.
These instructions are intended for the use by Gas Safe Register approved contractors or
registered Bord Gais installers in connection with the installation and putting into operation
of ATAG boilers. It is advisable to read these instructions thoroughly, well in advance of
installation. Separate instructions for use are supplied with the boiler for users of ATAG
central heating boilers. ATAG is not liable for the consequences of mistakes or shortcomings
which have found their way into the installation instructions or user’s manual. Further, ATAG
reserves the right to alter its products without prior notication.
When delivering the unit, give the customer clear instructions concerning its use;
present the customer with the user’s manual and card.
Each unit is tted with an identication plate. Consult the details on this plate to verify
whether the unit is compliant with its intended location, e.g.: gas type, power source and
exhaust classication.
On completion of the installation the installer or commissioning engineer must ll out
and complete the Benchmark Commissioning Checklist found on page 45 of this manual
and hand this to the customer for future record keeping. The Benchmark Service Record
must also be completed by the service agent following each service call, and return to
the customer. A copy of the Benchmark Commissioning Checklist must be returned to
ATAG Heating along with the warranty registration card to register the appliance for the
standard warranty benets.
Relevant Installation, Service and User manuals:
- ATAG Cascade Hydraulic cascade system
- ATAG Duopass Flue system individual
- ATAG BrainQ Digital room thermostat
- ATAG MadQ Cascade-/Zone controller
2 Rules
The following regulations apply to installation of ATAG central heating units:
Legislation and Regulations.
Gas Safety (Installation and Use). All gas appliances must by law, be installed by a competent
person, eg. Members of Gas Safe Register and in accordance with the current Gas Safety
Regulation. Failure to install appliance correctly could lead to prosecution.
All Gas Safe Register approved contractors carry a Gas Safe Register ID Card and have
a registration number. You can call Gas Safe Register direct on 01256 372300
In addition to the above regulations this appliance must be installed in compliance with
the current IEE Regulations, the Building Standards (Scotland Consolidation) Regulati-
ons. Regulations and bye laws of the Local Water Authority and the Current Health and
Safety Regulation.
The Benchmark Scheme
Benchmark places responsibilities on both manufacturers and installers. The purpose
is to ensure that customers are provided with the correct equipment for their needs,
that it is installed, commissioned and serviced in accordance with the manufacturer’s
instructions by competent persons and that it meets the requirements of the appropriate
Building Regulations. The Benchmark Checklist can be used to demonstrate compliance
with Building Regulations and should be provided to the customer for future reference.
To Next Page
Loading...
Need help?
General
