Handling of this instrument (Continued)
4
CAUTION
ە
The prism is made of optical glass. Do
not tap or contact its surface with any
metal tool such as a spoon or
tweezers.
If the surface of the prism is damaged,
inaccurate measurements will occur.
ە
After taking a measurement, completely
wipe off any sample on the surface of the
prism and surrounding area with tissue
paper soaked in water.
Then remove any remaining moisture
completely with dry tissue paper.
ە
If you have measured a sample of
polymer or fats and oils, wipe it off with
tissue paper soaked in alcohol or
neutral detergent.
Then remove any remaining moisture
completely with dry tissue paper.
ە
Always turn off the power switch after
use.
ە
When transporting the instrument,
place it in its original box.
Carefully read this instruction manual and fully understand the function and operation of
each part of the instrument before use.
Check that each part of the instrument operates normally before use.
Check the necessary operations such as calibration according to the instruction manual.
The manufacturer shall not be held responsible for any or all damages as a result of use
of the instrument for those other than its intended purposes (measurement of Brix, Refractive
Index, Concentration).
The prism mounted on the sample stage that is in contact with a sample under measurement
is a consumable item.
Ensure that if use of the instrument has undesired effects on the consumption of the
measured materials, etc., ATAG O shall not be held responsible for the result.
ە
ە
ە
ە
ە
ە
1. Precautions for use
To Next Page
Loading...
Need help?
General
