Answering system
108
Answering system settings
Number of rings
are no new messages. This feature allows you to check for new
messages and avoid paying long distance charges when calling from
out of your local area. By default, the answering system answers an
To set the number of rings:
1. When the handset is in idle mode, press
MENU/
SELECT to enter the main menu.
2. Press
CID or DIR to scroll to Answering sys,
then press MENU/SELECT.
3. Press
CID or DIR to scroll to Ans sys setup,
then press MENU/SELECT.
4. Press
CID or DIR to scroll to
#
of rings, then
press MENU/SELECT.
5. Press
CID or DIR to choose among 2, 3, 4, 5, 6
or Toll saver.
6. Press
MENU/SELECT
tone.
Notes:
If you subscribe to voicemail service through your telephone service provider, see Answering
system and voicemail indicators on page 112.
If you set the number of rings for the answering system as two or three rings, the caller ID
announce feature may not have enough time to announce the caller’s full information.
If Smart call blocker is on, the first ring of all incoming calls will be muted.
Call screening
># of rings
# OF RINGS
>4
To Next Page
Loading...
Need help?
General
