6. Press MENU/SELECT to confirm your setting and you hear a confirmation
tone. Press OFF/CLEAR to cancel.
NOTE: If you subscribe to voicemail service through your telephone service provider, see
Answering system and voicemail on page 59.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). Unless you change it, the remote
access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Remote code, then
press MENU/SELECT.
5. Use the dial pad to enter a two-digit number. Use
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to confirm your setting and you hear a
confirmation tone. Press OFF/CLEAR to cancel.
Answering system settings (handset only)
Telephone settings
>
Remote code
Msg alert tone
>
Ans sys setup
-End of list-
Play messages
>
Answering sys
REMOTE CODE
19
22
To Next Page
Loading...
Need help?
General
