AT&T DL72539 - Battery Installation and Charging

8
Getting started
Battery installation and charging
Once you have installed the battery, the screen indicates the battery status
(see the following table). For best performance, keep the handset in the
telephonebaseorchargerwhennotinuse.Thebatteryisfullychargedaer
16 hours of continuous charging. See the table in the Technical specications
section on page 109 for battery operating times.
Battery indicators Battery status Action
The screen is blank or
shows Put in charger
and ashes.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption (at least
30 minutes).
The screen shows
Low battery and
ashes.
Battery has enough
charge to be used for a
short time.
Charge without interruption (at least
30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged, place it in the
telephone base or charger when not in use.
1. Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label
THIS SIDE UP facing up, as indicated.
THIS
SIDE UP / CE
CÔTÉ VERS LE HAUT
Batt
ery
Pac
k /
Bl
o
c-pile
s :
BT
162342/BT26
234
2 (2.4V 300mAh Ni-
MH
)
WARNIN
G
/
AVERTIS
SEMENT
:
DO NOT BURN OR PUNCT
URE BA
T
TE
RIE
S
.
NE
PAS
I
NC
INÉRER
OU
P
ERC
ER LE
S P
ILES.
Made in
C
h
ina
/
F
abriqué en
ch
ine
CR
1535
THIS SIDE UP