AT&T DL72539 - Message Alert Tone

76
Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone is O.
To turn on or o the message alert tone:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press MENU/SELECT .
4. Press CID or DIR to highlight Msg alert tone, then press MENU/SELECT .
5. Press CID or DIR to choose On or O, then press MENU/SELECT .