Getting started
10
Wall-mount installation
The telephone base comes ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall-mount bracket to connect with
a standard dual-stud telephone wall-mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronics retailers. Professional assistance may be required to install the
mounting plate.
Tabletop to wall-mount installation
To change the telephone base from tabletop installation to wall-mount
installation, make sure you rst unplug the power adapter from the electrical
outlet and the telephone line cord from the telephone wall jack.
Plug the power cord and telephone line into the telephone base. If you
are using a DSL lter, plug the other end of the telephone line into the
lter. Route the telephone line cord (or DSL lter) through the wall-mount
bracket hole.
Position the telephone base, as shown below. Insert the extended tabs
(see illustration 2) of the wall-mount bracket into the slots on the back of
the telephone base (marked B). Push the telephone base down until it is
securely in place.
1.
2.
A DSL lter (not included) is
required if you have DSL
high-speed Internet service.
Wall-mount
bracket
1
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
