17
Telephone settings
Handset settings
Set date/time
The answering system announces the day of the week and time of each
message received prior to playing it. If you subscribe to caller ID service,
the day, month and time are set automatically with each incoming call (see
About caller ID on page 42). However, the year must be set so that the day
of the week can be calculated from the caller ID information.
Follow the steps, as mentioned below, to set the month, date, year and time.
Press MENU/SELECT in idle mode to enter the main
menu.
Press CID or DIR to scroll to Set date/time, and then
press MENU/SELECT.
Press CID or DIR to select the month, then press
MENU/SELECT, or enter the 2-digit number (01-12)
using the dialing keys (0-9).
Press CID or DIR to select the day, then press
MENU/SELECT, or enter the 2-digit number (01-31)
using the dialing keys (0-9).
Press CID or DIR to select the year, or enter the
2-digit number (00-99) using the dialing keys (0-9),
then press MENU/SELECT.
Press CID or DIR to select the hour, then press
MENU/SELECT, or enter the 2-digit number (00-23)
using the dialing keys (0-9).
Press CID or DIR to select the minute, then press MENU/SELECT, or enter
the 2-digit number (00-59) using the dialing keys (0-9).
Press CID or DIR to choose AM or PM. Press MENU/SELECT to save.
NOTE: If the date and time is not set when the message is recorded, the system announces
“Time and date not set” before it plays the message.
1.
2.
3.
4.
5.
6.
7.
8.
Set date/time
ECO
Date: MM/DD/YY
ECO
Time: HH:MM - -
ECO
To Next Page
Loading...
Need help?
General
Weight and Dimensions
