53
Answering system
Answering system settings
To record a new announcement:
Press MENU/SELECT when the handset is idle.
Press
CID or
DIR to scroll to Answering sys, then press MENU/SELECT.
Press MENU/SELECT to select Announcement. The system announces, “To
play, press 2. To record, press 7.”
Press 7. The system announces “Record after the tone. Press 5 when you
are done.”
Face the handset and speak towards the microphone to
record your announcement.
Press 5 when you finish the recording. The handset plays
back the recorded announcement.
NOTE: If the answering system memory is full, when you press 7 in Step 4, the answering
system announces, “Memory is full.” You must delete some messages before you can record
a new announcement. Refer to Message playback on pages 64-66.
To delete an announcement:
Press MENU/SELECT when the handset is idle.
Press
CID or
DIR to scroll to Answering sys, then press MENU/SELECT.
Press MENU/SELECT to select Announcement. The system announces, “To
play, press 2. To record, press 7.”
Press 2 to play the current announcement from the speakerphone.
Press 3 during playback to delete your recorded announcement. The
system announces, “Announcement deleted.”
If your announcement is deleted, calls are answered with the default
announcement, “Hello. Please leave a message after the tone.”
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
Recording... Stop
[5]
ECO
To Next Page
Loading...
