AT&T EP5962 - Belt Clip & Accessories

9
Getting Started
Belt clip & accessories
Install belt clip as shown below if desired.
For hands-free telephone conversations, you can use any industry standard 2.5 mm
headset (purchased separately). For best results use an AT&T 2.5 mm headset.
V
O
L
U
M
E
S
P
E
A
K
E
R
Snap belt clip into notches on
side of handset. Rotate and pull
to remove.
Plug 2.5 mm headset into jack
on side of handset (beneath
small rubber cap) or base.
Use DATA port at back of phone to
connect fax or modem if desired (data
port uses Line 2 only).
91-000302-050-000_EP5962Englishmanual_Sep.02,2005.qxd 2/13/1950 7:21 PM Page 9