13
Telephone Operation
HANDSET2 2
HANDSET1 1
HANDSET3 3
^ V
OK
Basic base operation
Hold
During a conversation, select HOLD to place a call on
hold.
CALL ON HOLD will be displayed for 4 seconds and
an H will appear in the upper left corner of the display.
Press the corresponding key (LINE 1 or LINE 2) to
resume the call.
NOTE
: If the call is not resumed in five minutes the set will ring. The dis-
play will show CALL ON HOLD RING BACK!. If the RING BACK is not
answered in 30 seconds, the call will end.
If you are on a call on the other line, your call will not be interrupted by the
RING BACK for the held line. The call on the held line will end in five minutes
with no warning.
Call transfer
During a conversation you can transfer the call to a handset.
Press TRANSFER to display a list of handsets. Use the
^V buttons to highlight the set you want, then select
OK to transfer the call to the remote set.
NOTE:
If the transferred call is not answered in 30 seconds, the call will
be returned to the base. Thirty seconds later, the base display will show
CALL ON HOLD RING BACK!. If the RING BACK is not answered in 30 sec-
onds, the call will end.
You can announce to the handset that you will transfer the call to them by
selecting HOLD and then pressing XFER. This will send an intercom signal.
When the intercom call is answered, you can talk privately. After the intercom
call ends (by pressing OFF on the handset or INTERCOM on the base), the
call will be transferred.
H
HOLD MUTEVOL
To Next Page
Loading...
Need help?
General
