12
Voicemail
Your AT&T Wireless Internet device comes with standard wireless voicemail. Follow
the steps below to set up and use your voicemail.
Setup
Dial 1 on any home phone connected to the AT&T Wireless Internet device and wait
four (4) seconds to be connected to your AT&T wireless voicemail. Simply follow the
voice prompts to complete setup. To enable remote voicemail retrieval and for added
security, be sure to create a password during setup.
Message Waiting
There are two indications that a new message is waiting: 1) the Voicemail light and
2) an intermittent dial tone.
The Voicemail light on your AT&T Wireless Internet device blinks green when
a voicemail message is waiting. You will also hear an intermittent dial tone on any
connected phone handset before placing a call.
Retrieving Messages
To retrieve voice messages, dial 1 on any home phone connected to the AT&T
Wireless Internet device, and wait four (4) seconds to be connected to your AT&T
wireless voicemail box. Simply follow the voice prompts to listen to and manage your
messages. Alternatively, you may dial your 10-digit home phone number to access
your voicemail box.
Remote Retrieval
To retrieve voicemail messages from a phone not connected to the AT&T Wireless
Internet device, dial the number associated with your AT&T Wireless Internet
service. When voicemail picks up press the * key. You will then be prompted to enter
your password. Simply follow the prompts to listen to and manage your voicemail
messages.
To Next Page
Loading...
