47
LAN Settings
(continued)
• Ethernet Port: Use this setting to enable or disable the Ethernet port on the
back of the device.
• IPv4 Address: This is the IPv4 address of the AT&T Wireless Internet device. By
default, this is set to 192.168.1.1.
• IPv4 Netmask: The IPv4 Netmask of the AT&T Wireless Internet device. By
default, this is set to 255.255.255.0
• DHCP Server: Enables or disables the DHCP server on the device. The DHCP
server allows the AT&T Wireless Internet device to automatically assign a local IP
address from the DHCP pool to wireless clients as they connect.
• DHCP Address Pool Start: The rst address in the DHCP pool which is assigned
to clients.
• DHCP Address Pool End: The last address in the DHCP pool which is assigned to
clients.
• DHCP Lease Time (hours): The length of the DHCP lease. This is the length of
time that the IP address is reserved for a particular client.
Active DHCP Leases
Displays the active DHCP leases and the length of time remaining.
Static Leases
Static leases are used to assign xed IP addresses and symbolic hostnames to DHCP
clients. By setting up a static lease, you can ensure that your device receives the
same IP address when it connects.
To Next Page
Loading...
