AT&T Merlin BIS 10 User Manual

OFTEN USED FEATURES
Auto Dial
To program:
1.
2.
3.
4.
5.
6.
7.
Label a button.
Slide T/P switch to P.
Press labeled button.
Dial
✱ 22 for inside
numbers, or ✱ 21 for
outside numbers.
Dial extension or outside
number. Include entire
dialing sequence, for
example, dial-out codes.
(See Special Characters
Table.)
Repeat Steps 3-5 to
program additional buttons.
Slide T/P switch to center.
To use auto dial button for ringing
calls:
●
Press programmed Auto
Dial button.
To use inside auto dial button for
voice-announced calls:
1. Press appropriate ICOM
Voice or SA Voice button.
2.
Press programmed Auto
Dial button.
3.
Begin talking after the
beep.
Personal Speed Dial
Program 2-digit codes with numbers
you dial most often, then use Feature
button to use these codes to dial a
number. (Feature available only on
lo-button telephones.)
To program personal speed
dial codes:
1.
2.
3.
4.
5.
Slide T/P switch to P.
Dial #and 2-digit
code (01-24), then dial ✱ 21.
Dial phone number or
account number. Include
entire dialing sequence, for
example, dial-out codes.
Special characters may be
needed (See Special
Characters Table).
Repeat Steps 2 and 3 to
program additional codes.
Slide T/P switch to center.
To use:
1.
Press Feature.
2.
Dial 2-digit code (01-24).
System Speed Dial
Use company-programmed 3-digit
codes to dial phone numbers. Ask
your system manager for a list of
numbers and their associated
codes.
To program:
1. Label a button.
2.
Slide T/P switch to P.
3.
Press button to be
programmed.
4.
Dial ✱ 24.
5.
Dial 3-digit company-
supplied speed dial code.
6. Slide T/P switch to center.
To use:
1. Lift handset.
2.
Press programmed button,
or press
Feature or dial #
and dial 3-digit company-
supplied speed dial code.
(Before using # sign, you
must lift handset.)
Special Characters Table
Features that dial numbers automatically may need special characters
to allow for correct dialing or system response.
Press...See... Means...
Drop s
Hold p
confer- f
ence
## #
# #
Stop. Halts dialing sequence to allow for system
response.
Pause. Inserts 1.5 sec. pause in dial sequence.
Multiple consecutive pauses allowed.
Flash. Sends switchhook flash. Must be first entry in
sequence.
For Extension Programming only ( [Prog] ): End of
Dialing. Used to signal end of dialing sequence or
used to separate grouped digits, for example,
account codes from number dialed.
End of Dialing. Used to signal end of dialing
sequence or used to separate grouped digits, for
example, account codes from number dialed.

AT&T Merlin BIS 10 Specifications

General

Brand	AT&T
Model	Merlin BIS 10
Category	Conference System
Language	English