AT&T Merlin BIS 10 - Call Waiting

OFTEN USED FEATURES
Call Waiting
Single beep means inside call
waiting; two beeps mean outside
call waiting.
To turn call waiting on/off:
1. Press Feature and dial 00.
2. Press any ICOM or SA
button.
3. Dial ✱ 11 to turn on or
✱✱ 11 to turn off.
4. Press
Feature and dial ✱ 00.
To complete a call and answer
call waiting:
1. When you hear Call Waiting
tone, hang up.
2. Lift handset when phone rings.
To put call on hold and pick up
call waiting:
1.
2.
3.
Press Hold.
Press ICOM Originate Only
or SA Originate Only button.
(You must have ICOM
Originate Only
or SA
Originate Only button
available to pickup call.)
Press Feature and dial 87.
To return to call on hold,
press button with fast
flashing light.
Pickup
To program:
1.
2.
3.
4.
5.
Label a button.
Slide T/P switch to P.
Press labeled button.
Select one of the following:
● Dial ✱ 9. For a specific
line or extension, dial line
number or extension.
● Dial ✱ 88 for group pickup.
Slide T/P switch to center.
To use:
●
Press programmed button,
or press
Feature and dial
9. If button not programmed
for specific line or extension,
you can manually dial line
number or extension, if
desired.
●
Group Pickup can also be
accessed by pressing
Feature and dialing 88.
Park
To program:
See
Programming Buttons.
To use park and speakerphone
page:
1. Park the call.
●
Press programmed Park
button.
●
Press Transfer, dial your
extension, and press
Transfer again or hang up.
2. Setup page.
●
1
2.
●
1.
For speakerphone page:
Press appropriate
Group Page or Page All
button, or press any
ICOM or SA button
and dial Group Page or
Page All extension.
Announce call and give
your extension.
For loudspeaker page:
Press programmed
Loudspeaker Page
button or press Feature
and dial 9 and loud-
speaker page line number.
If necessary, dial the code
for the page zone.
2. Announce call and
extension where call is
parked.
To pickup a parked call:
1.
2.
3.
Lift handset.
Press programmed
Pickup
button, or press Feature
and dial 9.
Dial extension where call is
parked.