Go to PBX Settings -> Outbound Routes, click to add an outbound route.
Outbound Route Name
A unique label to help you identify the outbound route.
Dial Pattern
A filter for marching numbers you dial, the call will be forwarded out via Selected Trunks only when it matches the
dial pattern here. In patterns, some characters have special meanings.
X means Any Digits from 0-9
Z means Any Digits from 1-9
N means Any Digits from 2-9
[1234-9] means Any Digits in the brackets (in this example, 1, 2, 3, 4, 5, 6, 7, 8, 9)
. means one or more digits
Strip: The number of digits that will be stripped from the front of the dialing string before the call is placed via
Selected Trunks.
For example: If set Dial Pattern: 9, Strip: 1, Prepend 123, user need to dial 94567 to dial PSTN number 1234567
Prepend these digits
Allows the user to specify digits that are prepended before the call is placed via the trunk.
Password
Authentication for Selected Extensions before dialing out.
Outbound Extension Selection
Select extensions which can dial out with this outbound route. In my case, only 6000,6001 can prefix 9 to dial out.
Outbound Trunk Selection
Select trunks which calls are forwarded out through. If there are more than one FXO trunk chose, PBX will try to
dial out through next trunk if the previous one failed.
To Next Page
Loading...
Need help?
General