ATCOM IPPBX IP08 - SIP Trunk to FXO Trunk

IPPBX IP08 User Manual
~ 48 ~ ATCOM TECHNOLOGY CO., LIMITED
7.7.2 SIP trunk to FXO trunk
1. Set outbound route for FXO trunk.
2. Set Inbound route for SIP trunk/Service Provider. Since service provider is more flexible, here we use Service
Provider as an example
Destination
Choose the proper FXO trunk
Number
Set a number on the other end of FXO trunk. it can be blank, then it means the number caller dialed.
3. Dial into IPPBX from SIP trunk, e.g. 83018618, then IPPBX will dial that number through FXO trunk selected
in PSTN outbound route.