Ateis PPM-IT5 - Command String and Logic Control; Sending ASCII Commands to Devices; Modifying Remote Logic Outputs

Command (String)
This function is used to send an ASCII command to a 3
rd
party device.
Write in the string combo, the ASCII command you will sent to the 3
rd
party device.
2 different modes:
- Time interval: number of time you will repeat the string and at what interval
- Time Out: When the IT5 will send commands to the 3
rd
party device, the device needs
to respond(+Ans) within the set time(+Time Out ?? ms), or repeat sending, send the
number of times(+Repeat) until the end.
Logic out (Old)
To modify the remote device logic out, you must first select the remote device (to be in
the list, the device must be added first in the device list window), the channel (which logic
output) and the value: