ATEN CS1792 - Powering Off and Restarting; Port ID Numbering

Chapter 3. Basic Operation
15
Powering Off and Restarting
If it becomes necessary to Power Off the unit, before starting it back up you
must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch’s power adapter cable.
3. Wait 10 seconds, then plug the switch’s power adapter cable back in.
4. After the switch is up, Power On the computers.
Port ID Numbering
Each KVM port on the CS1792 / CS1794 switch is assigned a port number (1
and 2 for the CS1792); 1, 2, 3, and 4 for the CS1794). The port numbers are
marked on the rear panel of the switch (see Rear View, page 8 for details).
The Port ID of a computer is derived from the KVM port number it is
connected to. For example, a computer connected to KVM port 2 has a Port ID
of 2.
The Port ID is used to specify which computer gets the KVM USB peripheral,
and audio focus with the Hotkey port selection method (see Going Directly to
a Port, page 18 for details).