Chapter 7. The Firmware Upgrade Utility
61
Adapter Cable Firmware Upgrade Recovery
To perform an adapter cable firmware upgrade recovery, do the following:
1. Unplug the adapter cable from the computer it is connected to.
2. Slide its Firmware Upgrade Recovery Switch (located next to the RJ45
connector) to the Recover position.
3. Plug the adapter cable back into the computer.
4. From your KVM switch console, bring up the OSD (see page 26) and
select the F4ADM function.
5. Scroll down to FIRMWARE UPGRADE. Press [Enter].
6. Press [Y] to invoke Upgrade mode.
7. Proceed with the firmware upgrade as described in Performing the
Upgrade, starting on page 56.
8. After the upgrade completes and the switch restarts, unplug the adapter
cable from the computer and slide the Firmware Upgrade Recovery Switch
back to the Normal position.
9. Plug the adapter cable back into the computer.
To Next Page
Loading...
