ATEQ D620 - Page 23

D620.388.00_QS_UK_01
23 / 42
Pneumatic outputs 0.6 MPa
DUMP: pneumatic output to connect to an
external valve for dump option.
SHUT OFF: pneumatic output to connect to
an external valve for shut off option.
A and B: automatic connectors option. These
connectors are used to drive pneumatic
caps on the part under test.
External capillary connectors
M1 and M2 connectors are pneumatic
inputs used for external capillary connection
(option).
External pressure monitoring connector
The P connector is a pneumatic input used
for external pressure monitoring connection
(option).
Test connector
The test connector is used to connect the device to the test to part for both direct and
indirect modes.
Metallic fitting diameter options (in mm):
— 4/6
— 6/8
— 8/10
— 15
— 20
— 25.