ATEQ D620 - Page 40

D620.388.00_QS_UK_01
40 / 42
Label Function Description
>RS232
- Configuration of the communication type on the RS232
port
>USB
- Sending result frames to a PC
>Date & Time
- Setup of the built-in clock
>OUTPUTS CONFIG.
- Configuration of the programmable outputs
>INPUTS CONFIG.
- Configuration of the programmable inputs
>CODE READER
- Bar code reader configuration
SECURITY
Security Security functions
>ACCESS
- Parameters access mode (key or password)
>START OFF
-
Deactivation of the Start on the instrument
front panel. Programs can only be started from
the instrument relay board.
MISCELLANEOUS
Miscellaneous
>SMART KEY
-
Configuration of the assigned function to the
Smart key
>BARGRAPH
- Bargraph display configuration
SERVICE menu
Use this menu to do the maintenance of your device (status check, internal tests...).
CAN STATUS
CA S US
I/O STATE
VALVE COUNTER
DEVICE INFOS
SERVICE CYCLES
RESET PARA
MAIN /SERVICE
Label Function Description
CAN STATUS
Internal network state State of the internal network of the device
I/O STATE
Inputs/outputs state State of the inputs/outputs
VALVE COUNTER
Valves wear function Approximate state of the valves wear
DEVICE INFOS
Device information Information about the device, program version,
built in components etc.
SERVICE CYCLES
Special service cycles Allows to display more special cycles to carry out
device internal tests
RESET PARA
Parameters reset Reset to factory configuration