QSG_D670_389.00_EN_01_2020-06-18
Allowed program automatic sequencing
Define if Pressure auto zero is done before, after
the cycle or on demand (not done automatically)
Calculate flow measurement at a specific
pressure value, whatever the real test pressure is
Define the method to control the electronic
pressure / flow regulator
Additional levels for specific reworkable parts
Pneumatic or electric output to identify the part
Calculate measured flow in other ATM pressure
and temperature condition (displays the unit with
an *)
Access to International System or American or
Custom Units
Available outputs for external automatism
CONFIGURATION menu
Use this menu to configure your ATEQ device.
Selection of the language displayed on the screen
Configuration of the pneumatics functions of the device
Out of cycle electronic regulator instruction choice
Pressure unit by default for the new programs
Configuration of the different communications between
the device and its environment
Configuration of the communication type on the RS232
port
Sending result frames to a PC
Setup of the built-in clock
If activated YES, the instrument will work in sequence
mode (32 sequences with 16 programs possible by
sequence) and the relay board inputs will select the
sequences
Configuration of the programmable outputs
Configuration of the programmable inputs
Bar code reader configuration
Parameters access mode (key or password)
Deactivation of the Start on the instrument front panel.
Programs can only be started from the instrument relay
board.
To Next Page
Loading...
Need help?
General
