EasyManuals Logo

ATEQ F670 Quick Start

ATEQ F670
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Quick start - F670
MR-36300C-U Quick start manual ATEQ F670 Page 20/25
2. MENU CONFIGURATION
This is to suit the device to the user's preferences.
Language: to select the language displayed on the screen.
Pneumatic: to configure the pneumatics functions of the device, the following
parameters are available:
¾ Regulator control
¾ Permanent regulator
¾ Piezzo automatic AZ, auto-zero carried on automatically with a defined frequency.
¾ Short Auto zero, to carry on an only pressure sensor auto-zero.
¾ Pressure Unit, pressure unit by default for the new programs.
¾ Blow mode, activation of the blowing between two test cycles.
¾ Dump level, warning concerning the part stayed under pressure at the end of cycle.
Automatism: to configure the different communications between the device and its
environment:
¾ RS232, to configure the communication type and the RS232 port.
¾ Date & Time, to set the built in clock.
¾ Change I/O, to configure the programmable inputs or outputs. See the installation
paragraph.
Security: security functions:
¾ Start OFF, deactivates the START key on the instrument front panel. Programs can
only be started from the instrument relay board.
Miscellaneous:
¾ Smart key, to configure the assigned to the "SMART KEY" key.
¾ Auto setup, to enables the automatic creation of a simple test program.

Other manuals for ATEQ F670

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ATEQ F670 and is the answer not in the manual?

ATEQ F670 Specifications

General IconGeneral
BrandATEQ
ModelF670
CategoryTest Equipment
LanguageEnglish

Related product manuals